HHP Lean Burn Gas Controls (GCP with PCS3100) Qualification (2004-02Q)

Course Overview

This course will allow participants to build on the knowledge obtained from the Cummins Virtual College ‘Self-Study’ Training programs, by discussing in detail the QSK19G, QSK60G and QSV Gas Engine and Generator Control Systems, including the Generator Control Panel fitted with PowerCommand Supervisor 3100. Technicians will also carry out practical tests and checks, using the required special tools, service software and service literature.

Who should attend

Cummins Authorised distributors and OEM’s

Course Objectives

Participants will demonstrate their knowledge of Cummins HHP Natural Gas Control Systems by undertaking a number of practical tasks. To achieve full Certification in the service and repair of Cummins HHP Lean Burn Gas Control Systems technicians will be required to successfully complete this course and gain on-site experience.

Course Content

Practical session investigating Fuel systems, Engine Ignition systems and Genset control Systems including the functions, layout and flow of the various engine systems and their control modules
Practical session carrying out system troubleshooting checks using the correct test procedures with reference to notes and service literature
Written and Practical Test

Pre-requisites

Pre-requisites as per your SPG on QSOL. Available online or through your local Cummins Certified Training Location.