HHP Lean Burn ‘V’ Engine Gas STELLAR Controls (GIB with PCC3300) Qualification (2010-12Q)

Course Overview

This course will allow participants to build on the knowledge obtained from the Cummins Virtual College ‘Self-Study’ Training programs, by discussing in detail the QSK60G and QSV Gas Engine and Generator Control Systems, including the Generator Interface Box fitted with PowerCommand Control 3300. Technicians will also carry out practical tests and checks, using the required special tools, service software and service literature.

Who should attend

Cummins Authorised distributors and OEM’s.

Course Objectives

Participants will demonstrate their knowledge of Cummins HHP Natural Gas Control Systems by undertaking a number of practical tasks. To achieve full Certification in the service and repair of Cummins HHP Lean Burn Gas Control Systems technicians will be required to successfully complete this course and gain on-site experience

Course Content
  • Practical session investigating Fuel systems, Engine Ignition systems and Genset control Systems including the functions, layout and flow of the various engine systems and their control modules
  • Practical session carrying out system troubleshooting checks using the correct test procedures with reference to notes and service literature
  • Written and Practical Test
Pre-requisites

Pre-requisites as per your SPG on QSOL. Available online or through your local Cummins Certified Training Location.