Power Command 3.X Qualification (2013-11Q)

Course Overview

This course will introduce participants to the Cummins PC3.X Controller in the stand alone mode on successful completion of CORE subject training undertaken on Cummins Learning Centre (CLC) and successful PC2.X Qualification (2008-13Q).

Who should attend

Cummins Power Generation Authorised Distributor and Dealer PowerGen Service Technicians, Project and Application Engineers and potential Trainers.

Course Objectives

Upon successful completion, participants will be able to identify, setup, calibrate, install and troubleshoot the PCC3300 and HMI320 using simulators and diagnostic tools and equipment.

Course Content

Theory sessions covering all aspects of the PCC3300 (FAE & HM) and the HMI320.
Practical activities using Simulators for programming and troubleshooting purposes, using InPower software as well as subject literature.
Practical tests to ensure participants fully demonstrate learning has taken place.
A final written test to confirm that participants can demonstrate the use of equipment literature and associated tooling.

Pre-requisites

CORE, PC2.X Qualification (2008-13Q) is the pre-requisite for this training course.